SAFETY INSTRUCTIONS
Safety instructions while workingY Always wear heavy-duty gloves when repairing the cutting
attachment. This is extremely sharp and can easily cause
cuts.
Y Always ensure you have a safe and stable working
position
Y Always use both hands to hold the machine. Hold the
machine at the side of your body.
Y Store the machine out of reach of children.
Y Use only original spare parts for repairs.
Basic working techniques
Y Hold the machine as close to your body as possible to get
the best balance.
Y Use your right hand to control the throttle setting.
Y Make sure that your hands and feet do not come near the
cutting attachment when the engine is running.
Y When the engine is switched off, keep your hands and feet
away from the cutting attachment until it has stopped
completely.
Y Watch out for stumps of branches that can be thrown out
during cutting.Y Make sure that the tip does not touch the ground.
Y Always lay the machine on the ground when you are not Y Do not rush the work, but work steadily until all the
using it.branches have been cut back cleanly.
Y Check the working area for foreign objects such as Y Always slow the engine to idle speed after each working
electricity cables, insects and animals, etc, or other operation. Long periods at full throttle without any load on
objects that could damage the cutting attachment, such the engine can lead to serious engine damage.
as metal items.
Y Always work at full throttle.
Y If any foreign object is hit or if vibrations occur stop the
machine immediately. Disconnect the HT lead from the Y Let the engine drop back to idle speed between each cut.
Long periods at full throttle can cause serious damage to
spark plug. Check that the machine is not damaged. the centrifugal clutch.
Repair any damage.
Y If anything gets caught up in the cutting attachment while
you are working, switch off the engine and let it stop WARNING! Never stand directly underneath
completely and remove the ignition lead before cleaning !a branch that is being cut. This could lead to
serious or even fatal personal injury.
the cutting attachment.
Y This machine is not electrically insulated. If the machine Observe great care when working close to overhead power
touches or comes close to high-voltage power lines it lines. Falling branches can result in short-circuiting.
could lead to death or serious bodily injury.
WARNING! Observe the applicable safety
Safety instructions after completing workregulations for work in the vicinity of
!
overhead power lines.
Y The transport guard should always be Ţtted to the cutting
attachment when the machine is not in use.
Y Make sure the cutting attachment has stopped before
cleaning, carrying out repairs or an inspection.
Disconnect the HT lead from the spark plug.
English � 13 |